Filter
Top Products
Control Panel Operation
CP 3800
6−39CM 4000 Installation and Operating Manual
DEST
SINGLE DESTINATION MODE (CONT’D)
2. Select a category.
After a valid category has been selected, the display will reflect the choice and if prompting is enabled, the valid number
buttons will illuminate in red in the category/number group.
Current Destination = PRODCTN4
Category = Vid_Tape Number = ??? New Destination = ????????
Figure 6−48. Example Destination Assignment Display Page − Category Selected.
3. Select a number.
Numbers may be selected as indicated by valid red illumination.
Current Destination = PRODCTN4
Category = Vid_Tape Number = 1 New Destination = VTR_0001
Figure 6−49. Example Destination Assignment Display Page − Category & One Digits Selected.
Current Destination = PRODCTN4
Category = Vid_Tape Number = 12 New Destination = VTR_0012
Figure 6−50. Example Destination Assignment Display Page − Category & Two Digits Selected.
4. Press TAKE. (A second TAKE will be needed to overwrite an old assignment.)
The destination selection operation may be completed using the TAKE button any time a valid selection has been made.
This will be indicated by the presence of a source name in the display after the display of “New Destination =” and the
fact that the TAKE button will be illuminated.
If the panel leaves the Single Destination mode (DEST button goes off), re−enter the mode by pressing DEST again and
selecting a destination to be controlled.
Pressing CLEAR at any time during the entry process will return the panel to the Destination Assignment No Selections
Made Mode. Selection of CLEAR at that state or reselecting the red DEST button at any time will cancel the operation
and return the panel to Single Destination Mode Home State.