Filter
Top Products
Control Panel Operation
CP 3800
6−34 CM 4000 Installation and Operating Manual
MULTIPLE DESTINATION MODE (CONT’D)
Adding or Changing a Destination Soft Key Assignment
A destination may be added to any unused location in the display. One additional page will be available when adding destina-
tion assignments.
Changing a destination that has already been defined on the panel is also possible.
Note: Destinations that have been defined in the panel’s CP Output set (page 5−79) cannot be changed. If an illegal
attempt to change a destination is made, the display will provide the following warning:
Existing Destination STUDIO_A Is System Defined And Can Not Be Changed
Category = Vid_Tape Number = ??? New Source = ????????
Figure 6−41. Example Destination Assignment In Process − Defined Destination Warning.
Adding or changing a destination is achieved by the following sequence:
1. Press the DEST button twice.
The button will blink red. The displayed change menu will appear:
1 Changing Destination − Use Up/Down Buttons and Soft Key to Select Position
VTR_0123 VTR_0124 VTR_0125 VTR_0126 STUDIO_A STUDIO_B STUDIO_C ENGINRNG
Figure 6−42. Example Destination Assignment − Change Menu.
All user defined locations will illuminate in green.
2. Select the soft key under the desired destination location.
3. Select the Category and Number for the destination.
The selected soft key will change to red. The display will update to indicate that a destination assignment is in process,
Category and number keypad entry, CLEAR, TAKE and display function as already described:
Assign Destination
Category = STUDIO Number = 3 New Destination = STUDIO_C
Figure 6−43. Example Destination Assignment In Process − Category & Two Digits Selected.
4. Press TAKE.