Filter
Top Products
Configurator
Tally
5−158 CM 4000 Installation and Operating Manual
TALLY DEPENDENCY
Figure 5−137. Tally Dependency table (example).
1
Tally Dependency
Tally Device
MCS_TLY
Opto
0
Logical Output
MAIN−A
Tally
2
3
MCS_TLY 1 MAIN−B
MCS_TLY 2 KEYINS1
4
5
MCS_TLY 3 KEYINS2
MCS_TLY 4 MIXINS1
6 MCS_TLY 5 MIXINS2
7 MCS_TLY 6 BYPASS
Password 5−22
Network Description 5−27
Serial Protocol 5−30
Switcher Description 5−35
Switcher Input 5−48
Switcher Output 5−55
Control Panel Sets
Level set 5−58
Input set 5−62
Output set 5−78
Override set 5−96
Sequence set 5−99
Category set 5−101
MPK Devices 5−107
Machines 5−135
Machine Control 5−139
Delegation Groups 5−149
Status Display Header 5−150
VGA Status Display 5−151
Tally
Path Finding 5−174
Exclusion 5−188
Y Line 5−189
Time Standard G−11
Video Reference G−14
CM VGA Options H−1
OVERVIEW
This table must be used when an MI 3040 has been configured to operate as a “MI 3040/T,” i.e., for operation with tally lamps.
The Tally Relay table must also be used (page 5−152).
Note 1: The Jupiter Tally system described in this manual cannot tally sources that are wired directly to a Saturn
internal matrix. If the Saturn is equipped with an internal matrix, the Saturn Tally system is available (but cannot
be connected to the Jupiter tally system). Please refer to the Saturn Installation and Operating Manual for addi-
tional information.
Note 2: The Tally Dependency table is also used for systems with under monitor status displays, when input mne-
monics must be tracked back through a master control or production switcher. See page 5−96.
The table has two basic purposes: first, to establish the identity of the main output of the system (the output being fed by the
tallied source); and second, to allow the Jupiter system to track sources through switchers other than the routing switcher.
Whatever source is feeding the main output (usually a transmitter) is tallied. When the main output is fed directly from the
routing switcher, it is referred to as an unqualified output; a sample entry is shown in Figure 5−138.
Figure 5−138. Entry used when main output is fed by router.
1
Tally Dependency
Tally Device
Opto Logical Output
XMIT
Tally
2