Filter
Top Products
6-74
COPYRIGHT
©
2000 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
CHAPTER 6 IMAGE FORMATION SYSTEM
Figure 6-E712
Figure 6-E713
[24]
[22]
[23]
[21]
[16]
[20]
[17]
[19]
[18]
[17]
[16]
Magnetic seal plate
8) Remove the C-ring [16], washer [17],
pressure roll [18], seal [19], washer [17],
butting roll [20], C-ring [16], and bearing
[21]; the, remove the two screws [22], and
detach the bushing [23] and then the de-
veloping sleeve [24].
Caution:
Do not leave fingerprints or oil on the
surface of the developing cylinder. Wipe
off any with lint-free paper. (Do not use
solvent.)
Points to Note When Mounting
the Developing Cylinder
Both front and rear sides of the develop-
ing assembly and the developing cylin-
der are equipped with a magnetic seal
plate.
When mounting the developing cylin-
der, take care not to bring the magnetic
seal plate into contact with the surface of
the cylinder to avoid damage.