Filter
Top Products
11-46
COPYRIGHT
©
1999 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
CHAPTER 11 INSTALLATION
Figure 11-C608
Table 11-C602
Caution:
1. If SW5-4 of the DIP switch on the
controller is set to OFF, group control
is disabled, and the following is indi-
cated:
2. If the copier's memory is used for ID
input (using the copier on its own), the
exiting ID Nos. may be used for the
controller. Perform the following:
! Drawing the ID Nos.
a) Set the DIP switch (SW1) of the controller
as follows:
b) Press the switch SW4 on the controller.
In response, LED5 turns on momentarily.
c) Check LED5; it should turn on to indicate
that the data has been drawn.
Otherwise, LED5 will flash. Press the
switch SW4 once again, and see that
LED5 turns on.
The copier cannot discharge paper while
data is being drawn.
d) Set the DIP switch (SW1) on the control
as follows (LED5 should turn off):
Table 11-C603
Figure 11-C609
SW1
bit
1,2
3
Position
ON
OFF
LED5
SW4
SW1-1SW1-2SW1-3
16
SW4
SW1
ON
SW5
ON
LED6LED5LED4
LED3LED2LED1
SW2
SW3
JB2
JB1
JA1
JA2
16
LED1 LED2 LED3
SW1
bit
1, 2, 3
Position
OFF