Filter
Top Products
COPYRIGHT
©
1999 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
10-33
CHAPTER 10 SIDE PAPER DECK
3. Removing the Deck Main Motor
(M101)
1) Detach the deck from the copier, and re-
move the six screws; then, detach the rear
cover.
2) Disconnect the two connectors [1], and re-
move the four screws [2]; then, detach the
deck main motor [3].
At this time, take care not to damage the
gear at the tip of the motor spindle.
4. Removing the Deck Lifter Motor
(M102)
1) Open the compartment of the deck, and
remove all copy paper.
2) Turn on the copier's power. If the lifter of
the deck is up, push down the sensor lever
[1] of the paper supply position sensor.
Stop the lifter [2] when it is about 7cm
from the base plate of the compartment,
and insert a hex wrench into the hole of
the lifter drive shaft [3] to hold it in place
(thereby preventing it from rotating).
Figure 10-C304
Figure 10-C305
Figure 10-C303
[2]
[1]
[3]
[1] [2]
7 cm (approx.)
[2]
[3] [4]