Filter
Top Products
COPYRIGHT
©
1999 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
8-31
CHAPTER 8 FIXING SYSTEM
Figure 8-B505
Figure 8-B506
Figure 8-B507
[3] [1]
[2]
Take up roller
Cleaning belt
feeding roller
[4]
2. Mounting the Fixing Cleaning Belt
Mount the fixing cleaning belt by revers-
ing the steps used to remove it.
1) Wind the cleaning belt [2] around the
cleaning belt take-up roller [1] two to
three times, and mount it so that the arm
guide plate [3] at the front is on the out-
side of the take-up roller.
At this time, check to make sure that the
area of contact with the roller is impreg-
nated with oil.
Caution:
Check the fixing cleaning belt for skew,
wrapping, and wrinkling. Further, be
sure that the winding direction and the
mounting orientation are as indicated.
2) After mounting the fixing cleaning belt,
move the plunger [4] of the cleaning belt
feeding solenoid into the direction of the
arrow.
Caution:
If you have replaced the cleaning belt, be
sure to return the setting under
COPIER>COUNTER>MISC>FIX-
WEB to '0' in service mode.