Filter
Top Products
COPYRIGHT
©
2000 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
13-215
CHAPTER 13 TROUBLESHOOTING
<FEEDER>
Level 3
DOCST
Description
Adjusting the Original Stop Position for Pickup from
the Feeder (original tray pickup)
Operation
1) Select DOCST.
2) Place paper on the tray (A3/11"x17").
3) Enter a setting using the keypad.
4) Press the OK key.
• The paper on the original tray will be picked up and
stopped on the copyboard glass.
5) Open the feeder slowly, and check the position of
the paper.
6) Close the feeder slowly without removing the paper.
7) Press the OK key.
• The paper on the copyboard glass will be delivered to
the original tray.
8) If the stop position is not as indicated, go back to
step 3), and make adjustments once again.
Remarks
Range : -35 to 35 (Each '1'
causes a shift of 0.5 mm)
• The data is retained by
the ADF controller PCB
on the feeder side.
Original stop position
Lower settingHigher setting
Standard:
11 ±1 mm
Original
FEEDER>ADJUST