Filter
Top Products
CHAPTER 13 TROUBLESHOOTING
13-116
COPYRIGHT
©
1999 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
84 Pickup operation fails. (side paper deck)
Step
1
2
3
4
5
6
Action
Close the doors firmly.
See the "The lifter fails
to move up."
If the roller is soiled,
clean it with alcohol; if
it is deformed by wear,
replace it.
Route the belt
correctly.
Check the drive belt,
gear, and coupling.
Replace the side paper
deck PCB.
Check the wiring up to
the clutch; if normal,
replace the clutch.
Checks
Are the upper right door and the lower
right door closed firmly?
Slide out the compartment from the deck.
Does the lifter move down? Further, is the
lifter heard to move up when the
compartment is slid in?
Does the pickup roller rotate?
Is the belt used to transmit the drive to the
pickup roller routed correctly?
Is the drive from the deck main motor
transmitted to the pickup assembly
through the drive belt, gear, and coupling?
Measure the voltage of the connector on
the side deck PCB. Does it change from
24 to 0 V when the Copy Start key is
pressed?
J104-7: CL101
J104-12: CL102
Cause
Upper right
door, Lower
right door
Lifter
Deck pickup
roller
Belt
Drive belt, Gear,
Coupling
Side deck driver
PCB
Deck pickup/
vertical path
clutch (CL102
for pickup;
CL101 for
feeding)
Yes/No
NO
NO
YES
NO
NO
NO
YES