Filter
Top Products
COPYRIGHT
©
1999 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
13-217
CHAPTER 13 TROUBLESHOOTING
<SORTER-Related Items>
<FEEDER-Related Items>
Level 3
LA-
SPEED
STRD-S
STRD-L
RVM-
SPD
Description
Adjusting the Original Feeding Speed for Stream
Reading Mode
Adjusting the Scanner Stop Position for Stream
Reading Mode (small-size)
Adjusting the Scanner Stop Position for Stream
Reading (large-size)
Adjusting the speed of Reversal Motor
• For details, see the Feeder Service Manual.
Remarks
Range : -54 to 54 (a
higher setting will
increase the speed)
• The data is retained by
the controller PBC of
the ADF on the feeder
side.
Range : -25 to 25 (each '1'
causes a shift of 0.1 mm)
• The data is retained by
the IP PCB on the
copier.
• If you have replaced the
IP PCB or initialized the
RAM on the IP PCB,
enter the value recorded
on the service label.
Range : -30 to 30 (each '1'
increases the speed by
0.1%)
• The data is retained by
the controller PBC of the
ADF on the feeder side.
Remarks
Range : 6 to 24mm (12mm
at default)
• The data is retained by
the finisher controller
PCB on the finisher side.
Copyboard glass
Stream reading scanner stop position
Higher setting
Lower setting
Copyboard glass
Stream reading scanner stop position
Higher setting
Lower setting
FEEDER>ADJUST
Description
Adjusting the offset for Punch Hole Position (feeding
direction)
• For details, see the Finisher Service Manual.
Level 3
PNCH-
HLE