Filter
Top Products
COPYRIGHT
©
1999 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
11-7
CHAPTER 11 INSTALLATION
No.
8
9
10
11
Work
Turn over the slope plates, and match the
pin holes of the skid and the pin holes of
the slope plates; then, fit the pins (one
each).
Holding the grips (front, rear) of the
copier, slide the copier down the slope
plates off the skid.
Caution:
The pins are taped in place to the
slopes.
Open the cardboard box that comes with
the copier, and take out the parts and sub
members. Check that none of the
attachments is missing.
Put away the grip used in step 4) in the
compartment behind the front cover.
Mount the face covers (right and left) that
have been removed.
Remarks
Grip
Front cover
Caution:
Before moving on to the next steps, check to see if there is condensation on the outside or the
inside of the copier right after taking it out of its shipping box. If condensation is found, stop
the work and wait until the copier has become used to the room temperature.
Start the steps that follow after making sure that the copier is free of condensation.
Slope plates
Pin