Filter
Top Products
10-38
COPYRIGHT
©
1999 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
CHAPTER 10 SIDE PAPER DECK
7. Routing the Lifter Cable
1) Check to make sure that the lifter drive shaft and the lifter are held in place with a hex wrench
[1] and long screwdrivers [2].
2) Secure the cable fixing plate [3] to the lifter with two screws.
3) Hook the lifter cable on the upper pulley [4].
4) Hook the ball of the lifter cable on the pulley [5] of the lifter drive shaft; then, wind the cable
along the groove of the pulley about 1.5 times. At this time, be sure to keep the lifter cable taut
until the long screwdrivers are slightly lifted and stopped.
5) Secure the pulley to the lifter drive shaft with two set screws [6].
6) Mount all pulleys that have been removed back to the lifter drive shaft; then, measure the
height from the base plate of the compartment to the top face of the lifter to ensure that the lifter
is level.
Figure 10-C315
(rear)
[3]
[6]
[5]
[1]
[3]
[2]
[5]
[6]
[3]
[4]
[3]
[4]