Filter
Top Products
COPYRIGHT
©
2000 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
13-259
CHAPTER 13 TROUBLESHOOTING
C. Finisher-D1 Self Diagnosis
Code Cause
• The data communication has an error.
• The backup RAM (EEPROM) is faulty.
• The inlet motor (M1) is faulty.
• The stack delivery motor (M7) is faulty.
• The stack delivery motor clock sensor
(PI12) is faulty.
• The front jogging plate motor (M4) is
faulty.
• The front jogging plate home position
sensor (PI7) is faulty.
• The rear jogging plate motor (M5) is
faulty.
• The rear jogging plate home position
sensor (PI9) is faulty.
• The stapler motor (M11) is faulty.
• The stapler home position detecting
sensor (PI9) is faulty.
• The swing guide safety switch (MSW2)
is faulty
• The stapler safety switch (front; MSW8)
is faulty.
• The stapler safety switch (rear; MSW9)
is faulty.
Description
• The communication between the copier
and the machine has been interrupted and,
in addition, is not corrected after 5 sec
during which re-transmission was tried.
• After the above condition, a recovery
attempt has been tried three times in 5
sec.
• The communication between the master
CPU (IC101) and the slave CPU (IC121)
has been disrupted.
• The check sum has an error at power-on.
• The clock pulses from the inlet motor
are 50 mm/sec or less for 1 sec or more
while the motor is in operation.
• The clock pulses from the stack delivery
motor clock sensor are 50 mm/sec or
less for 1 sec or more while the motor is
in operation.
• The front jogging plate does not leave
the front jogging plate home position
sensor when the front jogging plate
motor has been driven for 4 sec.
• The front jogging plate does not return to
the front jogging plate home position
sensor after the front jogging plate motor
has been driven for 4 sec.
• The rear jogging plate does not leave the
rear jogging plate home position sensor
when the rear jogging plate motor has
been driven for 4 sec.
• The rear jogging plate does not return to
the rear jogging plate home position
sensor after the rear jogging plate motor
has been driven for 4 sec.
• The stapler does not leave the stapler
home position after the stapler motor has
been driven for 0.5 sec.
• The stapler does not return to the stapler
home position when the stapler motor
has been driven for 0.5 sec.
E500
E501
E505
E514
E510
E537
E530
E531