Filter
Top Products
COPYRIGHT
©
1999 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
13-15
CHAPTER 13 TROUBLESHOOTING
C. Image Formation System
See Chapter 6> VII.C. "Charging Wires."
See Chapter 6> VII.C. "Charging Wires."
See Chapter 6> VII.F. "Drum Cleaner Unit."
See Chapter 6> VII.E. "Developing Assembly."
1) Check to make sure that the data lamp on the control panel is off, and turn off the main
power switch.
2) Disconnect the power plug.
Caution:
The copier remains powered as long as the power plug is connected to the power outlet even
after the main power switch is turned off. Be sure to disconnect the power plug.
3) Replace the potential sensor/potential control PCB.
Caution:
The potential sensor and the potential control PCB are adjusted as a pair. Be sure to replace
both of them if either of them must be replaced.
1 Routing the Primary Charging Assembly Grid Wire
2 Routing the Charging Assembly Charging Wires
3 Mounting the Drum Cleaning Blade
4. Mounting the Developing Blade
5 Replacing the Potential Sensor/Potential Control PCB