Filter
Top Products
CHAPTER 13 TROUBLESHOOTING
13-216
COPYRIGHT
©
1999 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
<FEEDER>
Level 3
DOCST-
M
Description
Adjusting the Original Stop Position for Pickup for the
Feeder (manual tray pickup)
Operation
1) Select DOCST-M.
2) Place paper on the manual feed tray (A3/11"×17").
3) Enter a setting using the keypad.
4) Press the OK key.
• The paper on the manual feed tray will be picked up
and stopped on the copyboard glass.
5) Open the feeder slowly, and check the position of
the paper.
6) Close the feeder slowly without removing the paper.
7) Press the OK key.
• The paper on the copyboard board glass will be
delivered to the manual feed tray.
8) If the stop position is not as indicated, go back to
step 3), and make adjustments once gain.
Remarks
Range : -50 to 50 (Each '1'
causes a shift of 0.5 mm)
• The data is retained by
the ADF controller PCB
on the feeder side.
Original stop position
Lower settingHigher setting
Standard:
11 ±1 mm
Original
FEEDER>ADJUST