Filter
Top Products
CHAPTER 13 TROUBLESHOOTING
13-262
COPYRIGHT
©
2000 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
Code
E535
E532
E540
E531
E530
E542
Item
• Swing motor (M8)
• Swing guide open sensor
(PI16)
• Staple shift motor (M10)
• Stapler shift home position
sensor (PI7)
• Tray A lifting motor (M13)
• Tray A lock sensor (PI25)
• Tray A upper position
sensor (PI28)
• Tray A lower position
sensor (PI27)
• Swing motor (M8)
• Swing guide closed sensor
(PI15)
• Rear jogging plate motor
(M5)
• Rear jogging plate home
position sensor (PI9)
• Stapler motor (M6)
• Staple home position
detecting switch (MS7)
• Tray B lift motor (M12)
• Tray B locked sensor (PI23)
• Tray B lower limit sensor
(PI24)
• Tray B upper position
sensor (PI20)
• Tray lower position sensor
(PI21)
Description
• The swing guide closed sensor does not detect the swing
guide when the swing motor has been rotated for 2 sec.
(detail code FF)
• The stapler shift home position sensor does not turn off
when the stapler shift motor has been driven for 4 sec.
• The stapler shift home position cannot be detected when
the stapler shift motor has been driven for 4 sec.
• When the tray lifting motor is run, lifting is not
completed within 25 seconds.
• Clock input from the tray idling sensor has been
interrupted for 250 ms during motor rotation.
• Tray A is positioned below the tray B area.
• The stapler does not leave the stapling home position
when the stapler motor has been driven for 0.5 sec or
more.
• The stapler does not return to the stapling home position
when the stapler motor has been driven for 0.5 sec.
• The swing guide closed sensor does not detect the swing
guide when the swing motor has been rotated for 2 sec.
(detail code 01)
• The rear jogging plate does not leave the rear jogging
plate home position sensor when the rear jogging plate
motor has been driven for 4 sec.
• The rear jogging plate does not return to the rear jogging
plate home position sensor when the rear jogging plate
motor has been driven for 4 sec.
• The upward movement does not end within 25 sec when
the tray lift motor has been driven.
• The clock pulses from the tray idle rotation sensor while
the motor is rotating stop for 250 msec.
• The input from the tray B position sensor (PI20) is 0 at
power-on. (Tray B is above the tray paper sensor PCB.)
E551
• Power supply fan (FM1)
• Punch fan (FM2)
• An outage of the power fan for 2 seconds or longer has
been detected (detail code 01).
• An outage of the punch fan for 2 seconds or longer has
been detected (detail code 02).