Filter
Top Products
High-performance Embedded Workshop 5. Tools Administration
REJ10J1837-0100 Rev.1.00 Nov. 16, 2008
111
To change the tools directory location
1. Select [Tools -> Administration]. The Tools Administration dialog box opens.
2. Click the Modify button, which is next to the Current HEW tools location field.
3. Browse to the root directory of the new tool location and click the OK button.
4. This will switch the directory and change the tool location to the new directory. It will be necessary to scan for
any new tools that may be in this location. This can be achieved by using the Search Disk or Register Tool
functionality.
5.3 Registering a component
The High-performance Embedded Workshop will automatically attempt to register any new components installed since
the last time it was invoked. However, in some circumstances you may need to register components yourself.
In some cases it is useful to search a drive for High-performance Embedded Workshop-compatible components. This is
especially useful if the High-performance Embedded Workshop installation was deleted or corrupted, as it can recreate
your tool information instantly.
To search for components and register them
1. Click the Search Disk button on the Tools Administration dialog box. The Search Disk for Components
dialog box opens.
2. Enter the directory in which you would like to search into the top field, or browse to it graphically by clicking
the Browse button.
3. Check the Include Subfolders checkbox if you would like to search the directory specified and all directories
below it.
4. Click the Start button to begin the search. During the search, the Start button will change to a Stop button.
Click the Stop button to halt the search at any time.
5. The results of the search are shown in the Located Components list. Select a component and click the
Register button to register an individual component, or click the Register All button to register all located
components.
6. Click the Close button to exit the dialog box.