Filter
Top Products
High-performance Embedded Workshop 17. Using the Debugger
REJ10J1837-0100 Rev.1.00 Nov. 16, 2008
355
To configure the PD debugger to integrate with High-performance Embedded Workshop
1. Firstly, the location of the debugger executable must be specified. This may have been configured by the
installation program or a project generation utility.
2. The second item of data is the profile file. This tells the debugger which profile file to load when it is
launched. This file stores the debug setup information.
3. The third item of data is the command line options. This field allows additional options to be specified which
can modify the behavior of the external debugger.
4. Finally, the location of the download module is required. This allows the High-performance Embedded
Workshop to automatically switch to the debugger when the download module changes after a build.
17.16.3 Configuring an external debugger to integrate with High-performance Embedded Workshop
Th
e following details the information required to setup an external debugger which is not Hitachi Debugging Interface
or the PD debugger to integrate with High-performance Embedded Workshop and launch from the external debugger
option in High-performance Embedded Workshop.