Filter
Top Products
High-performance Embedded Workshop 3. Advanced Build Features
REJ10J1837-0100 Rev.1.00 Nov. 16, 2008
75
3.4 Setting custom build phase options
Once you have defined a custom phase, you will want to specify the command line options that should be used when it
is executed. Each defined phase has a menu option in the Build menu. To specify options for that phase select it. The
dialog that will be displayed depends on whether the custom phase selected was multiple or single (according to the
selection of phase type when it was created in the New Build Phase wizard).
If the phase selected was multiple then a list of project files is displayed on the left-hand side of the dialog to enable you
to specify the build options on a file by file basis. If the phase selected was single then there is no project file list
displayed. In either case, the three tabs below are available. This is where you can set the options that you want to apply
to the selected file(s). You can also choose which configurations are being viewed. In the configuration list, each
configuration is listed along with a special entry named Multiple configurations. If you select Multiple
configurations then the Select project configurations to modify dialog box is displayed which allows you to select
more than one configuration. This method is used throughout High-performance Embedded Workshop for modifying
multiple configurations at once.
3.4.1 Options tab
Th
is tab allows you to define the command line options that will be passed to the phase. The Command field displays
the command that was entered when you defined the phase. Enter into the Options field the command line arguments
that you would like to pass to the command. If you want to insert a placeholder, select the relevant placeholder from the
Placeholder drop-down list and then click the Insert button. See Reference 5, Placeholders, for more information on
placeholders.