Filter
Top Products
High-performance Embedded Workshop 3. Advanced Build Features
REJ10J1837-0100 Rev.1.00 Nov. 16, 2008
78
Notes:
• Irrespective of what these controls are set to, the build will always halt if a fatal error is encountered.
• When projects are dependent on one another, building stops if an error occurs in the child project and its parent
project will not be built.
• Note the following descriptions when you check the Stop build if the number of errors exceeds check box and
specify a number to the controls.
i. The build will stop immediately once the maximum number of errors or warnings is exceeded. It will not
continue to the end of the current phase.
ii. When the number of errors in one execution of a tool exceeds the specified number, the number of error
messages displayed on the “Output” window is the specified number plus one. A message saying that the
number of error has exceeded the specified number is NOT displayed on the Output window.
The same things as Stop build if the number of errors exceeds shown above hold also in Stop build if the number of
warnings exceeds. There is no correlation between Stop build if the number of errors exceeds and Stop build if the
number of warnings exceeds. They are independent.
3.6 Logging build output
The High-performance Embedded Workshop allows you to write the results of each build to file.
To specify a log file
1. Select [Setup -> Customize]. The Customize dialog box opens.
2. Select the Log tab.
3. Select the Generate build log checkbox.
4. Enter the full path of the log file into the Path field, or browse to it graphically by clicking the Browse button,
or click the placeholder button (
) and select the placeholder from the pop-up menu.
5. Click the OK button to confirm the new log file settings.
3.7 Changing toolchain version
If two or more versions of the same toolchain are registered in the High-performance Embedded Workshop, you can
choose a version of the toolchain on the Change Toolchain Version dialog box. To invoke the dialog, select [Tools ->
Change Toolchain Version]. Choose one of the versions from the Toolchain version drop-down list and click the OK
button to enforce your choice.