Filter
Top Products
TMP92CZ26A
92CZ26A-250
This bit is used to enable or disable the interrupt to be generated when the calculation of
error address and error bit position has ended.
The interrupt is enabled when this bit is set to “1” and disabled when “0”.
(e) <INTRDY>
The <INTRDY> bit is used for both Hamming and Reed-Solomon codes.
This bit is used to enable or disable the interrupt to be generated when the status of the
NDR/B pin of the NAND Flash changes from “busy” (0) to “ready” (1). The interrupt is
enabled when this bit is set to “1” and disabled when “0”.
(f) <STATE3:0> <SEER1:0>
The <STATE3:0> and <SEER1:0> bits are used only for Reed-Solomon codes. When using
Hamming codes, they have no meaning.
These bits are used as flags to indicate the result of error address and error bit
calculation. For details, see
Table 3.11.2.