Toshiba H1 Series Network Card User Manual


 
TMP92CZ26A
92CZ26A-600
AD Conversion Result Register 0 Low
7 6 5 4 3 2 1 0
bit Symbol ADR01 ADR00 OVR0 ADR0RF
Read/Write R R R
After reset 0 0 0 0
Function Store Lower 2 bits of
AN0 AD conversion
result
Overrun flag
0:No generate
1: Generate
AD conversion
result store
flag
1: Stored
AD Conversion Result Register 0 High
7 6 5 4 3 2 1 0
bit Symbol ADR09 ADR08 ADR07 ADR06 ADR05 ADR04 ADR03 ADR02
Read/Write R
After reset 0 0 0 0 0 0 0 0
Function Store Upper 8 bits of AN0 AD conversion result
AD Conversion Result Register 1 Low
7 6 5 4 3 2 1 0
bit Symbol ADR11 ADR10 OVR1 ADR1RF
Read/Write R R R
After reset 0 0 0 0
Function Store Lower 2 bits of
AN1 AD conversion
result
Overrun flag
0:No generate
1: Generate
AD conversion
result store
flag
1: Stored
AD Conversion Result Register 1 High
7 6 5 4 3 2 1 0
bit Symbol ADR19 ADR18 ADR17 ADR16 ADR15 ADR14 ADR13 ADR12
Read/Write R
After reset 0 0 0 0 0 0 0 0
Function Store Upper 8 bits of AN1 AD conversion result
9 8 76543210
Channel X conversion result
7 6 5 4 3 2 1 0 7 6 5 4 3 2 1 0
Figure 3.23.6 AD Conversion Registers
A
DREG0L
(12A0H)
A
DREG0H
(12A1H)
A
DREG1H
(12A3H)
A
DREGxH ADREGxL
Bits 5 2 are always read as “0”.
Bit 0 is the AD conversion result store flag <ADRxRF>. When AD conversion result is stored, the flag is set to “1”.
When Lower register (ADRECxL) is read, this bit is cleared to “0”.
Bit 1 is the Overrun flag <OVRx>. This bit is set to “1” if a next conversion result is written to the ADREGxH/L
before both the ADREGxH and ADREGxL are read. This bit is cleared to “0” by reading Flag.
A
DREG1L
(12A2H)