Filter
Top Products
show ipv6 cam stack-unit
Displays the IPv6 CAM entries for the specified stack-unit.
S4820T
Syntax
show ipv6 cam [vrf vrf-name] stack-unit unit-number port-set
{0-1} [summary | index | ipv6 address]
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the
VRF to display IPv6 CAM entries corresponding to that VRF.
NOTE: If you do not specify this option, IPv6 CAM entries
corresponding to the default VRF are displayed.
unit-number Enter the stack unit’s ID number.
port-set Enter the keyword Port Set.
summary (OPTIONAL) Enter the keyword summary to display a table
listing network prefixes and the total number prefixes which
can be entered into the IPv6 CAM.
index (OPTIONAL) Enter the index in the IPv6 CAM.
ipv6-address Enter the IPv6 address in the x:x:x:x::x/n format to display
networks that have more specific prefixes. The range is
from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
1002
IPv6 Basics