Filter
Top Products
14
Debugging and Diagnostics
The basic debugging and diagnostic commands are supported by the Dell Networking Operating System.
This chapter contains the following sections:
• Diagnostic and Monitoring Commands
• Offline Diagnostic Commands
• Hardware Commands
Diagnostics and Monitoring Commands
The following section describes the diagnostics and monitoring commands.
For similar commands, refer to the Control and Monitoring chapter.
logging coredump stack-unit
Enable coredump on a stack.
Syntax
logging coredump stack-unit {stack-unit-number | all}
Parameters
stack-unit
stack-unit-
number
Enter the stack-unit id.
all Enable coredump on all stack-unit.
Defaults Enabled by default on customer builds.
Command
Modes
CONFIGURATION
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
612
Debugging and Diagnostics