Filter
Top Products
If the state of an object changes back to its former UP/DOWN state before the
timer expires, the timer is cancelled and the client is not notified. For example, if
the DOWN timer is running when an interface goes down and comes back up, the
DOWN timer is cancelled and the client is not notified of the event.
If the timer expires and an object’s state has changed, a notification is sent to the
client. If no delay is configured, a notification is sent immediately after a change in
the state of a tracked object is detected. The time delay in communicating a state
change is specified in seconds.
Related
Commands
• track interface ip routing – configures object tracking on the routing status of
an IPv4 Layer 3 interface.
• track interface line-protocol – configures object tracking on the line-protocol
state of a Layer 2 interface.
• track ip route metric threshold – configures object tracking on the threshold of
an IPv4 route metric.
• track ip route reachability – configures object tracking on the reachability of an
IPv4 route.
description
Enter a description of a tracked object.
Syntax
description {text}
To remove the description, use the no description {text} command.
Parameters
text Enter a description to identify a tracked object (80 characters
maximum).
Defaults none
Command
Modes
OBJECT TRACKING (conf_track_object-id)
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Related
Commands
• track interface ip routing – configures object tracking on the routing status of
an IPv4 Layer 3 interface.
• track interface line-protocol – configures object tracking on the line-protocol
state of a Layer 2 interface.
• track ip route metric threshold – configures object tracking on the threshold of
an IPv4 route metric.
1242
Object Tracking