Filter
Top Products
0/49 12 up up
0/50 12 up down
0/51 24 up up
1/49 12 up up
1/50 12 up up
2/49 24 up up
2/51 12 up up
2/52 12 up down
Dell#
Example
(Topology)
Dell# show system stack-ports topology
Topology: Ring
Interface Connection
----------------------
0/49 1/49
0/50
0/51 2/49
1/49 0/49
1/50 2/51
2/49 0/51
2/51 1/50
2/52
Dell#
Related
Commands
• reset stack-unit – resets the designated stack member.
• show hardware stack-unit – displays the data plane or management plane input
and output statistics of the designated component of the designated stack
member.
• show system (S-Series and Z-Series) – displays the current status of all stack
members or a specific member.
stack-unit priority
Configure the ability of a switch to become the management unit of a stack.
Syntax
stack-unit stack-unit number priority 1-14
Parameters
stack-number Enter the stack member unit identifier.
1–14 This preference parameter allows you to specify the
management priority of one backup switch over another,
with 0 the lowest priority and 14 the highest. The switch with
the highest priority value is chosen to become the
management unit if the active management unit fails or on
the next reload.
Defaults 0
1754
Stacking