Filter
Top Products
enable
Enable uplink state group tracking for a specific UFD group.
Syntax
enable
To disable upstream-link tracking without deleting the uplink-state group, use the
no enable command.
Defaults Upstream-link tracking is automatically enabled in an uplink-state group.
Command
Modes
UPLINK-STATE-GROUP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T
8.3.12.0 Introduced on the S4810.
8.4.2.3 Introduced on the S-Series S50.
Related
Commands
• uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
show running-config uplink-state-group
Display the current configuration of one or more uplink-state groups.
Syntax
show running-config uplink-state-group [group-id]
Parameters
group-id Displays the current configuration of all uplink-state groups
or a specified group. The valid group-id values are from 1 to
16.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
1824
Uplink Failure Detection (UFD)