Filter
Top Products
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.2.3 Introduced on the S-Series S50.
Example
Dell#show running-config uplink-state-group
!
no enable
uplink state track 1
downstream TenGigabitEthernet 1/2,4,6,11-19
upstream FortygigabitEthernet 1/27, 29
upstream PortChannel 1
!
uplink state track 2
downstream TenGigabitEthernet 1/1,3,5,7-10
upstream FortygigabitEthernet 1/31,42
Related
Commands
• show uplink-state-group — displays the status information on a specified
uplink-state group or all groups.
• uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
show uplink-state-group
Display status information on a specified uplink-state group or all groups.
Syntax
show uplink-state-group [group-id] [detail]
Parameters
group-id Displays status information on a specified uplink-state group
or all groups. The valid group-id values are from 1 to 16.
detail Displays additional status information on the upstream and
downstream interfaces in each group
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Uplink Failure Detection (UFD)
1825