Filter
Top Products
To delete the site-of-origin community, use the no set extcommunity
command.
Parameters
as4 ASN4:NN Enter the keyword as4 then the 4-octet AS specific
extended community number in the format ASN4:NN (4-
byte AS number:2-byte community value).
ASN:NNNN Enter the 2-octet AS specific extended community number
in the format ASN:NNNN (2-byte AS number:4-byte
community value).
IPADDR:NN Enter the IP address specific extended community in the
format IPADDR:NN (4-byte IPv4 Unicast Address:2-byte
community value).
non-trans (OPTIONAL) Enter the keywords non-trans to indicate a
non-transitive BGP extended community.
Defaults none
Command
Modes
ROUTE MAP (config-route-map)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the E-Series.
Usage
Information
If the set community rt and soo are in the same route-map entry, the behavior
defines as:
• If the rt option comes before soo, with or without the additive option, soo
overrides the communities rt sets.
• If the rt option comes after soo, without the additive option, rt overrides
the communities
soo sets.
• If the rt with the additive option comes after soo, rt adds the communities
soo sets.
Related
Commands
set extcommunity rt — sets the extended community route origins using the route-
map.
530
Border Gateway Protocol