Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced.
Usage
Information
This command turns on BGP soft-reconfiguration inbound debugging. If no
neighbor is specified, debug turns on for all neighbors.
debug ip bgp updates
Allows you to view information about BGP updates.
S4820T
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] updates [in | out | prefix-list prefix-list-
name]
To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D
| X:X:X:X::X | peer-group peer-group-name] updates [in | out |
prefix-list prefix-list-name]
command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to view BGP updates information corresponding to
that VRF.
A.B.C.D (OPTIONAL) Enter an IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group
peer-group-
name
(OPTIONAL) Enter the keyword peer-group followed by the
name of the peer group.
440
Border Gateway Protocol