Filter
Top Products
Defaults Layer 3
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
The input policy map is used to classify incoming traffic to different flows using
class-map, QoS policy, or incoming packets DSCP. This command enables Policy-
Map-Input Configuration mode (conf-policy-map-in).
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
service-policy input — applies an input policy map to the selected interface.
policy-map-output
Create an output policy map.
S4820T
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name
command.
Parameters
policy-map-
name
Enter the name for the policy map in character format (32
characters maximum).
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1478
Quality of Service (QoS)