Filter
Top Products
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For the Management interface on the stack-unit, enter
the keyword ManagementEthernet then the slot/port
information. The slot range is from 0 to 1. The port range
is 0.
• For a port channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series ExaScale
(the prior limit was 2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Added the access-group option.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.3.1.0 Added the count option.
Usage
Information
The following describes the debug ip packet command in the following
example.
Field Description
s= Lists the source address of the packet and the name of the
interface (in parentheses) that received the packet.
IPv4 Routing
907