Filter
Top Products
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
OSPFv3 Commands
Open shortest path first version 3 (OSPFv3) for IPv6 is supported on the S4820T platform.
The fundamental mechanisms of OSPF (flooding, DR election, area support, SPF calculations, and so on)
remain unchanged. However, OSPFv3 runs on a per-link basis instead of on a per-IP-subnet basis. Most
changes were necessary to handle the increased address size of IPv6.
The Dell Networking implementation of OSPFv3 is based on IETF RFC 2740.
area authentication
Configure an IPsec authentication policy for OSPFv3 packets in an OFSPFv3 area.
S4820T
Syntax
area area-id authentication ipsec spi number {MD5 | SHA1} [key-
encryption-type] key
Parameters
area area-id
Area for which OSPFv3 traffic is to be authenticated. For
area-id, you can enter a number.
The range is from 0 to 4294967295.
ipsec spi
number
Security Policy index (SPI) value that identifies an IPsec
security policy.
The range is from 256 to 4294967295.
MD5 | SHA1
Authentication type: Message Digest 5 (MD5) or Secure Hash
Algorithm 1 (SHA-1).
1344
Open Shortest Path First (OSPFv2 and OSPFv3)