Filter
Top Products
• + = (plus) the sequences in a pattern (one or more
sequences).
• ? = (question mark) sequences in a pattern (either zero or
one sequences).
NOTE: Enter an escape sequence (CTRL+v) prior to
entering the ? regular expression.
• [ ] = (brackets) a range of single-character patterns.
• ( ) = (parenthesis) groups a series of pattern elements
to a single element.
• { } = (braces) minimum and the maximum match count.
• ^ = (caret) the beginning of the input string. If you use
the caret at the beginning of a sequence or range, it
matches on everything BUT the characters specified.
• $ = (dollar sign) the end of the output string.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp flap command shown in the
following example.
Field Description
Network Displays the network ID to which the route is flapping.
From Displays the IP address of the neighbor advertising the
flapping route.
Flaps Displays the number of times the route flapped.
Border Gateway Protocol
503