Filter
Top Products
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Added support for the tunnel interface type.
9.1(0.0) Updated Management Ethernet output to include two
global IPv6 addresses on S4810 and Z9000 and added
output example showing OpenFlow instance ID.
8.3.12.1 Updated command output to support multiple IPv6
addresses on S4810.
8.3.11.4 Output expanded to support eSR4 optics in Z9000.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.2 Included SFP and SFP+ optics power detail in the E-Series
and C-Series output.
8.2.1.0 Added support for 4093 VLANs on the E-Series ExaScale.
Prior releases supported 2094.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Output expanded to include SFP+ media on the C-Series.
7.6.1.0 Introduced on the S Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Changed the organization of the display output.
6.3.1.0 Added the Pluggable Media Type field in the E-Series
TeraScale output.
Usage
Information
Use the show interfaces command for details on a specific interface.
NOTE: In the CLI output, the power value is rounded to a 3-digit value. For
receive/transmit power that is less than 0.000, an snmp query returns the
corresponding dbm value even though the CLI displays as 0.000.
NOTE: After the counters are cleared, the line-rate continues to increase until
it reaches the maximum line rate. When the maximum line rate is reached,
there is no change in the line-rate.
User
Information
The following table describes the show interfaces command shown in the 10G
(TeraScale) Example.
Interfaces
825