Filter
Top Products
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage
Information
IS-IS normally purges LSPs with an incorrect data link checksum causing the LSP
source to regenerate the message. A cycle of purging and regenerating LSPs can
occur when a network link continues to deliver accurate LSPs even though there is
a link causing data corruption. This process could cause disruption to your system
operation.
ip router isis
Configure IS-IS routing processes on an interface and attach an area tag name to the routing process.
Syntax
ip router isis [tag]
To disable IS-IS on an interface, use the no ip router isis [tag] command.
Parameters
tag (OPTIONAL) The tag you specify identifies a specific area
routing process. If you do not specify a tag, a null tag is
assigned.
Defaults No processes are configured.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1050
Intermediate System to Intermediate System (IS-IS)