Filter
Top Products
Version Description
7.6.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series.
dot1x server-timeout
Configure the amount of time after which exchanges with the server time-out.
Syntax
dot1x server-timeout seconds
To return to the default, use the no dot1x server-timeout command.
Parameters
seconds Enter a time-out value in seconds. The range is from 1 to
300, where 300 is implementation dependant. The default is
30.
Defaults 30 seconds
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
When you configure the dot1x server-timeout value, take into account the
communication medium used to communicate with an authentication server and
the number of RADIUS servers configured. Ideally, the
dot1x server-timeout
value (in seconds) is based on the configured RADIUS-server timeout and
retransmit values and calculated according to the following formula: dot1x
802.1X
213