Filter
Top Products
Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage
Information
To enable the interface to send both version of RIP packets, use the ip rip send
version 1 2 command.
Related
Commands
ip rip receive version — sets the RIP version for the interface to receive traffic.
version — sets the RIP version for the switch software.
ip split-horizon
Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme
prevents any routes learned over a specific interface to be sent back out that interface.
S4820T
Syntax
ip split-horizon
To disable split-horizon, use the no ip split-horizon command.
Defaults Enabled
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
Routing Information Protocol (RIP)
1523