Filter
Top Products
27
IPv6 Access Control Lists (IPv6 ACLs)
IPv6 ACLs and IPv6 Route Map commands are supported on Dell Networking S4820T platform.
NOTE: For IPv4 ACL commands, refer to the Access Control Lists (ACL) chapter.
Important Points to Remember
• Certain platforms require manual CAM usage space allotment. For more information, refer to the
cam-acl command.
• Egress IPv6 ACL and IPv6 ACL on the Loopback interface is not supported.
• Reference to an empty ACL permits any traffic.
• ACLs are not applied to self-originated traffic (for example, Control Protocol traffic not affected by
IPv6 ACL because the routed bit is not set for Control Protocol traffic and for egress ACLs the routed
bit must be set).
• You can use the same access list name for both IPv4 and IPv6 ACLs.
• You can apply both IPv4 and IPv6 ACLs on an interface at the same time.
• You can apply IPv6 ACLs on physical interfaces and a logical interfaces (Port-channel/VLAN).
• Non-contiguous masks are not supported in source or destination addresses in IPv6 ACL entries.
• Because the prefix mask is specified in /x format in IPv6 ACLs, inverse mask is not supported.
show cam-acl-egress
Show information on FP groups allocated for egress ACLs.
S4820T
Syntax
show cam-acl-egress
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
IPv6 Access Control Lists (IPv6 ACLs)
975