Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
show logging
Display the logging settings and system messages logged to the internal buffer of the switch.
Syntax
show logging [number | history [reverse][number] | reverse
[number] | summary]
Parameters
number (OPTIONAL) Enter the number of messages displayed in the
output. The range is from 1 to 65535.
history (OPTIONAL) Enter the keyword history to view only
information in the Syslog history table.
reverse (OPTIONAL) Enter the keyword reverse to view the Syslog
messages in FIFO (first in, first out) order.
summary (OPTIONAL) Enter the keyword summary to view a table
showing the number of messages per type and per slot. Slots
*7* and *8* represent RPMs.
Command
Modes
EXEC
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Example
(Partial)
Dell#show logging
Syslog logging: enabled
Console logging: level debugging
Monitor logging: level debugging
Buffer logging: level debugging, 5604 Messages Logged,
Simple Network Management Protocol (SNMP) and Syslog
1737