Filter
Top Products
sflow collector
Configure a collector device to which sFlow datagrams are forwarded.
Syntax
sflow collector {ip-address | ipv6-address} agent-addr {ip-
address | ipv6-address} [number [max-datagram-size number]] |
[max-datagram-size number] [vrf management]
To delete a configured collector, use the no sflow collector {ip-address |
ipv6-address} agent-addr {ipv4-address | ipv6-address} [number
[max-datagram-size number]] | [max-datagram-size number] [vrf
management] command.
Parameters
sflow collector
ip-address |
ipv6-address
Enter the IP address of the collector in dotted decimal
format for IPv4 or x:x:x:x::x format for IPv6.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
agent-addr ip-
address | ipv6-
address
Enter the keyword agent-addr followed by the sFlow agent
IP address in dotted decimal format for IPv4 or x:x:x:x::x
format for IPv6.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
number (OPTIONAL) Enter the user datagram protocol (UDP) port
number. The range is from 0 to 65535. The default is 6343.
max-
datagram-size
number
(OPTIONAL) Enter the keyword max-datagram-size then the
size number in bytes. The range is from 400 to 1500. The
default is 1400.
vrf
management
(OPTIONAL) Enter the keyword vrf followed by the keyword
management to configure the collector device
corresponding to the default VRF and the management VRF
respectively.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
sFlow
1681