Filter
Top Products
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for NFS mount.
9.2(1.0) Introduced on the Z9500.
9.0(0.0) Added support for IPv6 for the file-url parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000. Added support for the SSD on the
Z9000 only.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added support for TFTP and SCP.
7.6.1.0 Introduced on the S-Series.
Usage
Information
RFC 3986 specifies that IPv6 host addresses in a uniform resource identifier (URI)
must be enclosed in square brackets, [X:X:X:X::X]. For maximum flexibility this
command accepts IPv6 host addresses with or without the square brackets.
After you upgrade the system image, by entering the command. specify the
location where the Dell Networking OS image used to boot the system is stored
(boot system), save the configuration to the start-up config file (write memory),
and reload the system (reload).
Example
Dell# upgrade system tftp://10.11.8.12/dv-rainier-13 a:
00:39:32 : Discarded 1 pkts. Expected block num : 51. Received
block num: 50
!00:39:36 : Discarded 1 pkts. Expected block num : 65.
Received block num: 64
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!...................................................
...............................................................
...............................................................
.............!
93924044 bytes successfully copied
System image upgrade completed successfully.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!
Image upgraded to all
78
File Management