Filter
Top Products
Route Map Commands
When you create an access-list without any rule and then applied to an interface, the ACL behavior
reflects implicit permit.
To configure route maps and their redistribution criteria, use the following commands.
continue
To a route-map entry with a higher sequence number, configure a route-map.
Syntax
continue [sequence-number]
Parameters
sequence-
number
(OPTIONAL) Enter the route map sequence number. The
range is from 1 to 65535.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
The continue feature allows movement from one route-map entry to a specific
route-map entry (the sequence number). If you do not specify the sequence
number, the
continue feature simply moves to the next sequence number (also
known as an implied continue). If a match clause exists, the continue feature
executes only after a successful match occurs. If there are no successful matches,
the continue feature is ignored.
Match clause with Continue clause
Access Control Lists (ACL)
291