Filter
Top Products
IP Prefix List Commands
When you create an access-list without any rule and then apply it to an interface, the ACL behavior
reflects implicit permit.
To configure or enable IP prefix lists, use these commands.
clear ip prefix-list
Reset the number of times traffic mets the conditions (“hit” counters) of the configured prefix lists.
Syntax
clear ip prefix-list [prefix-name]
Parameters
prefix-name (OPTIONAL) Enter the name of the configured prefix list to
clear only counters for that prefix list, up to 140 characters
long.
Defaults Clears “hit” counters for all prefix lists unless a prefix list is specified.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increase the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Related
Commands
ip prefix-list — configures a prefix list.
Access Control Lists (ACL)
283