Filter
Top Products
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.5.1.0 Added support for LSP Throttling Enhancement.
Usage
Information
The refresh interval determines the rate at which route topology information is
transmitted preventing the information from becoming obsolete.
The refresh interval must be less than the LSP lifetime specified with the max-lsp-
lifetime command. A low value reduces the amount of time that undetected link
state database corruption can persist at the cost of increased link utilization. A
higher value reduces the link utilization the flooding of refreshed packets causes.
Related
Commands
max-lsp-lifetime — sets the maximum interval that LSPs persist without being
refreshed.
max-area-addresses
Configure manual area addresses.
Syntax
max-area-addresses number
To return to the default values, use the no max-area-addresses command.
Parameters
number Set the maximum number of manual area addresses. The
range is from 3 to 6. The default is 3.
Defaults 3 addresses
Command
Modes
ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
Intermediate System to Intermediate System (IS-IS)
1067