Filter
Top Products
Also, if you configure different passwords on the two routers, the following
message appears on the console:
%RPM0-P:RP1 %KERN-6-INT: BGP MD5 password mismatch from
[peer's IP address] : 11502 to [local router's IP address] :179
neighbor peer-group (assigning peers)
Allows you to assign one peer to an existing peer group.
S4820T
Syntax
neighbor {ip-address | peer-group peer-group-name} dmzlink-bw
To delete a peer from a peer group, use the no neighbor {ip-address |
peer-group
peer-group-name} command.
To disable dmzlink-dw for the peer group, use the no neighbor ip-address
dmzlink-dw command.
Parameters
ip-address Enter the IP address of the router to be included in the peer
group.
peer-group-
name
Enter the name of a configured peer group.
dmzlink-bw Enter the keyword dmzlink-bw to attach a link bandwidth
to received routes.
NOTE: If dmzlink-bw is configured for a peer, in order
for the BGP peer to advertise the prefixes with dmzlink-
bw attached to it, you must reset the the peer or peer-
group using the clear ip bgp session command.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added the dmzlink-bw parameter.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Border Gateway Protocol
459