Filter
Top Products
To insert the community list into the COMMUNITY attribute, use the no set
comm-list community-list-name delete command.
Parameters
community-
list-name
Enter the name of an established Community list, up to 140
characters.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information
The community list used in the set comm-list delete command must be
configured so that each filter contains only one community. For example, the filter
deny 100:12 is acceptable, but the filter deny 120:13 140:33 results in an
error.
If the set comm-list delete command and the set community command
are configured in the same route map sequence, the deletion command (set
comm-list delete) is processed before the insertion command (set
community
).
Related
Commands
match community — redistributes routes that match the COMMUNITY attribute.
set community — specifies a COMMUNITY attribute.
Access Control Lists (ACL)
307