Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to display adjacent router information
corresponding to that VRF.
level-1 (OPTIONAL) Displays information about Level 1 IS-IS
neighbors.
level-2 (OPTIONAL) Displays information about Level 2 IS-IS
neighbors.
detail (OPTIONAL) Displays detailed information about neighbors.
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
For a port channel interface, enter the keywords port-
channel then a number.
For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command
Modes
EXEC
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage
Information
Use this command to confirm that the neighbor adjacencies are operating
correctly. If you suspect that they are not, you can verify the specified area
addresses of the routers by using the show isis neighbors command.
The following describes the show isis neighbors command shown in the
following example.
Intermediate System to Intermediate System (IS-IS)
1089