Filter
Top Products
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.0 Introduced on the E-Series.
Usage
Information
You cannot use Class D or Class E IP addresses or zero IP address (0.0.0.0) when
creating a static ARP. Zero MAC addresses (00:00:00:00:00:00) are also invalid.
You can use the vrf attribute of this command to create a static ARP entry on
either a default or a non-default VRF. You cannot use this parameter to create any
static ARPs corresponding to management VRFs. When a VRF is deleted using the
no ip vrf command, all the static ARP configurations that belong to that VRF
are removed automatically.
Related
Commands
clear arp-cache — clears dynamic ARP entries from the ARP table.
show arp — displays the ARP table.
arp backoff-time
Set the exponential timer for resending unresolved ARPs.
S4820T
Syntax
arp backoff-time seconds
892
IPv4 Routing