Filter
Top Products
(comma-separated): 3, 4, 6. Range (hyphen-separated):
5-10.
Slot/Port information need not contain a space before and
after the dash. For example. both of the following
commands are valid: interface group
tengigabitethernet 1/1 - 5 ; interface group
tengigabitethernet 1/1-5
; ; .
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command
Modes
CONFIGURATION
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL
Switch.
Usage
Information
The interface group command will create all the non-existent VLANs specified
in the range. On successful command execution, the CLI switches to the interface
group context.
The configuration commands inside the group context will be the similar to that of
the existing range command.
Note: For release 9.4(0.0), the group command is supported only for VLANs and
physical interfaces.
Example
Dell(conf)#interface group ?
fortyGigE FortyGigabit Ethernet interface
gigabitethernet GigabitEthernet interface IEEE 802.3z
tengigabitethernet TenGigabit Ethernet interface
vlan VLAN keyword
Dell(conf)# interface group vlan 1 - 2 , tengigabitethernet
1/10
Dell(conf-if-group-vl-1-2,te-1/10)# no shutdown
Dell(conf-if-group-vl-1-2,te-1/10)# end
Related
Commands
interface range — Configures a range of interfaces.
interface vlan — Configures a VLAN.
Interfaces
801